Zum Inhalt

espnow_button_node.tc

A battery wall button: asleep almost all the time, a key press wakes it, it sends ONE ESP-NOW packet to the receiver and sleeps again.

Source on GitHub

// @name: ESP-NOW button node
// A battery wall button: asleep almost all the time, a key press wakes it, it sends ONE ESP-NOW packet to the receiver and sleeps again.
// Packet: 'B', button id, action (1 = toggle). The receiver (the lamp controller, see espnow_receiver.tc) decides what the id means.
//
// SETUP ONCE on the node (console):   WiFi 0       -> the node never connects to the WiFi (stored). Set autoexec for this program.
//   Build with -DTC_AUTOEXEC_MIN_UPTIME=0 (or low): by default main() starts 3 s after boot, which is 3 s of battery per press.
// CHANNEL is the channel of the receiver's access point (WiFi router, fixed!). ESP-NOW only reaches a receiver on that channel.
// WAKE_PIN: ESP32-C3 GPIO 0..5 wake from deep sleep. Key from the pin to GND, ~1 MOhm from the pin to 3.3 V (drains only while pressed).
//
// Battery life is decided by the board's sleep current (regulator, LED): measure it. One press costs roughly 0.3-1 s of ~60 mA.

#define CHANNEL    11
#define RECEIVER   "AA:BB:CC:DD:EE:FF"
#define BUTTON_ID  1
#define WAKE_PIN   3
#define INPUT_PULLUP 5

char pkt[4];

int main() {
    int ok = 0;
    int tries = 0;
    int t0 = millis();
    espnowBegin(CHANNEL);
    espnowPeer(RECEIVER);
    pkt[0] = 'B';
    pkt[1] = BUTTON_ID;
    pkt[2] = 1;
    while (ok == 0 && tries < 4) {
        ok = espnowSend(RECEIVER, pkt, 3);
        tries = tries + 1;
    }
    addLog("NODE: button %d, delivered %d after %d tries, %d ms awake", BUTTON_ID, ok, tries, millis() - t0);
    pinMode(WAKE_PIN, INPUT_PULLUP);
    t0 = millis();
    while (digitalRead(WAKE_PIN) == 0 && millis() - t0 < 3000) { delay(20); }   // wait for the key to be released, or it wakes us again at once
    delay(30);
    deepSleepGpio(0, WAKE_PIN, 0);                  // 0 = no timer, wake when the pin goes LOW
    return 0;
}